| Modified HF transceiver. I've talked to Italy on this thing with no amplifier. Great unit for mobile or base station use. Worked fine the last time it was used. I just do not have a antenna these days & have other things going on. Some specs below:
Key Features
* Full Band Coverage - Covers the 10 Meter Amateur Band from 28.0000 to 29.6999 MHz. * All Mode Operation - Operates on USB, LSB, CW, AM and FM. * Brightness Control - Four Step LCD brightness control for easy viewing under any condition. * Repeater Offset Switch - Gives you standard offsets for repeater operation. * Programmable Frequencies - Allows you to program up to 10 individual frequencies. Includes battery backup. * Built in Dual VFO - Choose steps of 10kHz, lkHz or 100Hz, manual or scan * RIT - Receiver Incremental Tuning to fine tune the receive frequency up to +/- 3kHz. * Squelch - Cuts off or eliminates receiver background noise in the absence of incoming signals. * Noise Blanker - Greatly reduces repetitive impulse noise. * RF Gain Control - Reduces the gain of the receiver under strong signal conditions to prevent overloading. * RF Power Output Selector - Lets you select transmitting output power * External Speaker Connection - Place a speaker anywhere for convenient listening. * PA Mode - Use an external speaker for a mobile PA system. * LCD Display - Large, easy to read backlit LCD display. * Multi-Function LCD Meter - Indicates transmit power, receive signal strength, modulation, SWR Calibration and SWR.
Specifications
General
* Frequency Range: 28.0000~29.6999 MHz * Tuning Steps: 100Hz, 1kHz, 10kHz, 100kHz, 1MHz * Emission Types: USB, LSB(A3J), CW(A1), AM(A3), FM(F3) * Frequency Control: Phase-Locked Loop Synthesizer * Frequency Tolerance: 0.005% * Frequency Stability: 0.001% * Operating Temperature Range: 0 to 40 degrees C. * Antenna Impedance: 50 Ohms * Microphone: 400 Ohms, Dynamic PTT * Speaker: 8 Ohms, 2 Watts * Display: Digital Frequency, LCD * Meter Function: RF Output, Receive Signal Strength, Modulation, SWR Calibration, SWR * Power Requirements: 13.8 Volt DC Negative Ground
Transmitter
* Antenna Connector: UHF TYPE, 50 Ohm * RF Transmit Modes: USB, LSB, CW, AM, FM * RF Output Power: USB, LSB (25W); CW (8W); AM/FM (8W) * Spurious Emissions: -50dB * Carrier Suppression (SSB Modes): -50 dB
Receiver
* Sensitivity for 10dB SINAD: AM 0.5uV * Sensitivity for 10dB SINAD: USB/LSB/CW 0.15uV * Sensitivity for 12dB SINAD: FM 0.25uV * Image Rejection Ratio: 65dB * AGC Figure of Merit: SSB/CW/AM 80dB for 50mV for 10dB Change in Audio Output * Audio Output Power: 2.5 Watts |